Posted on Leave a comment

Safety Corridors – Forward Base – Building Instructions

General notes:

1) This kit is made of Acrylic. There will be a thin plastic-like protective layer on the back of the acrylic parts, to protect the underside of acrylic from scorch marks and dirt from the lasering process. You will need to peel this layer from the underside of all parts before glueing them together.

2) Acrylic parts are held in the frame by small lugs, roughly 0.5mm-1mm wide. Parts should be CUT from the frame, from the reverse side, using a strong knife (we recommend the “Olfa L-1 Heavy Duty”)
Do NOT push parts from the frame using your fingers as this may result in damage to the part.

3) We recommend dry-fitting parts before assembly – this usually highlights either missing parts, wrong parts and/or difficult/tricky elements before glueing and ultimately saves time and making mistakes.

4)For glue, we recommend Deluxe Materials Tacky Glue, alternatively a good tacky glue or a strong PVA. Make sure to be careful to not over-apply glue, use it sparingly so you don’t mark the surface of the acrylic.

 

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.